Woodstock W1784 Manual do Utilizador

Phone: (360) 734-3482 • Online Technical Support: [email protected] © JUNE, 2007 BY WOODSTOCK INTERNATIONAL, INC., REVISED OCTOBER, 20

Model W1784 (Mfg. Since 2/07)-8-            

Model W1784 (Mfg. Since 2/07)-9- The jammed staple should be visible in the discharge area.— If the jammed staple can be removed with needle nose

Model W1784 (Mfg. Since 2/07)-10- Use a 5mm hex wrench to remove the four cap screws that secure the base to the stapler body (see ).

Model W1784 (Mfg. Since 2/07)-11-Use a good solvent to clean the nose assembly of the stapler. Always be sure that the

Model W1784 (Mfg. Since 2/07)-12-5 4 3 1 65 6 7 8 9 10 11 12 13 14 15 33 32 31 30 29 28 27 26 25 24 23 22 35 37 38 39 37 38 19 18 17 1

Model W1784 (Mfg. Since 2/07)-13-REF PART # DESCRIPTION REF PART # DESCRIPTION1 X1784001 CYLINDER 39 X1784039 L-BOLT3 X1784003 BUMPER 40 X1

Model W1784 (Mfg. Since 2/07)-14-  Air leaking at whack cap area.1. O-rings in plunger/cylinder h

CUT ALONG DOTTED LINEName ___________________________________________________________________________________Street __________________________________

TAPE ALONG EDGES--PLEASE DO NOT STAPLEFOLD ALONG DOTTED LINEPlaceStampHereFOLD ALO

Woodstock International, Inc. warrants all Shop Fox machinery to be free of defects from workmanship and materials for a period of two years from the

This manual provides critical safety instructions on the proper setup, operation, maintenance and service of this machine/equipment. Failure to read,

Model W1784 (Mfg. Since 2/07)-1- and in working order. 

Model W1784 (Mfg. Since 2/07)-2-for the tool. Make sure your air hose is in good condition and is long enough to reach your w

Model W1784 (Mfg. Since 2/07)-3- Do not place your hands near the staple point of entry. A staple can deflect and tear through the s

Model W1784 (Mfg. Since 2/07)-4-             

Model W1784 (Mfg. Since 2/07)-5-The Model W1784 is designed to be operated at 70-100 PSI using clean, dry, regulated, compressed air. 

Model W1784 (Mfg. Since 2/07)-6-This tool has been carefully packaged for safe transportation. If you notice the tool has been damaged d

Model W1784 (Mfg. Since 2/07)-7-When replacing staples in your Model W1784, follow these guidelines:Staple Gauge ......